Spliffigami: How To Make A Flying Dutchman

maxresdefault (5)


This article was published on Herb.co

If you ever wanted to be a pirate, then this is the joint smoking device for you! A ship that rides on the clouds, this device can burn 7 joints at once: I give you the Flying Dutchman.

Step 1: Hull of the Flying Dutchman

Cut out 2 foot-long-or-longer arched shapes from cardboard. To draw it out, you can use a rectangle, and extend one side out half the length of the rectangle to a single point, then draw curved arches from the end of the rectangle to the point. This will give you the basic hull shape. Now take one of the pieces and cut about a quarter of the length off of the square end. The shorter piece will be your base, the longer one your deck.

Now take one of the pieces and cut about a quarter of the length off of the square end. The shorter piece will be your base, the longer one your deck.

Step 2: Posts

Cut three identical posts of 3-4 inches in height from rigid plastic straws. Use poster putty to position the three posts on the larger hull piece, so that there are 2 at the flat end, and one in the…

Previous ArticleNext Article

Leave a Reply

Your email address will not be published. Required fields are marked *